Waxness Spa Choice Mango is a rosin-free wax, very flexible and plastic, low temperature with a dense, creamy consistency, suitable for Brazilians and sensitive skin areas. Characterized by very low adhesion to the skin. Specially formulated to be applied and removed in any direction. Scented with a delicious fruity mango fragrance.
Directions: Melt wax over low heat. Temperature: max 42 degrees C (107.6 degrees F). Test for correct temperature. WARNING: Hot wax may cause skin burns. Ensure skin is clean. Prep skin with powder or lotion if necessary. Evenly apply wax regardless of hair growth direction but towards to you, not wider than 1-1/2 inch The wax will be ready to remove once it is no longer sticky to the touch. Flick the lower part of the strip, keeping the skin taut. Pull the wax strip off briskly, close and parallel to the skin. When treatment is completed, apply an astringent product followed by a soothing oil or lotion.
Warnings: Please read the instructions on the package in full before proceeding with the treatment. Failure to follow instructions and warnings may result in severe skin irritation and other injuries.
NOTE: This is a pre-melted product. You will usually receive it in granule form, but occasionally you may receive it in chunks, a mix of chunks and beads, bigger pieces or bricks. This will not affect the quality of the product that can be used normally.
Italwax Film Wax Natural 100g / 3.52 - Exclusive hot wax with the lowest melting temperature (40-42oC / 104-107oF) - No strips required - Ultimate product form: pellets are universally loved for convenience and cost-effectiveness - Superior grip for stubborn, coarse hair - Impeccable salon results even after 1st use
Top Formula wax raw material is synthetic resin. Top Formula synthetic waxes never cause allergy andirritation on delicate, sensitive skin. Top formula wax tend to be more adhesive and remove all the hairs from the first try. The wax has lower melting temperature +37/+39 degrees C (98-100F).
- Designed for short hair and problematic hair removal - High-density resin with a creamy texture - Non-transparent - Contains titanium dioxide and zinc oxide - Melting temperature: 39-40 degrees - Suitable for sensitive skin
Suitable for removal of short, coarse hair. High content of Titanium Dioxide. Advanced adhesion. Effective for removal of short and coarse hair. Melting temperature 48 - 50 C degrees.
No review at the moment
0 review
